Jodi Mullins, Cosmetic Medicine Book with Jodi

Home Laser & energy

Treatment

Healite II LED phototherapy.

Low-level light that may support skin recovery and help calm inflammation, most often used alongside other treatments. Its effects are gentle, and it works within a broader plan rather than on its own.

At a glance

Treatment type
LED phototherapy (photobiomodulation)
Treatment time
Typically 10–20 minutes, depending on the protocol
Comfort measures
Eye protection. Most people find it comfortable, with mild warmth at most.
Downtime
Usually none from the LED itself
Treatment course
Depends on the purpose: one or a few sessions around a procedure, or a short course such as 1–2 sessions a week over several weeks
Results develop
Effects on recovery are judged over days; effects on skin quality or breakouts over several weeks
Maintenance
Sometimes, depending on why it is being used
Consultation required
Yes, to check suitability and decide whether LED adds anything for you

What is it?

Healite II is a clinic LED (light-emitting diode) device. It shines specific wavelengths of visible and near-infrared light onto the skin at a low, measured dose. The light doesn’t heat, cut or remove skin, and it contains no ultraviolet (UV) light.

Healite II has three wavelengths, used in different protocols:

  • 415 nm (blue light), which acts close to the skin surface and is mainly used for mild to moderate inflammatory breakouts;
  • 633 nm (red light), which reaches into the upper dermis and is used to support skin recovery and general skin quality;
  • 830 nm (near-infrared light), which is invisible to the eye, penetrates the deepest of the three, and is used mainly for recovery and calming inflammation.

Which protocol, and which wavelength or combination, is used depends on why you are having LED. Which protocols Jodi uses, and for what: Jodi to confirm.

What may it help with?

Healite II LED is mostly used as a supporting treatment. It may help with:

  • skin recovery after other procedures, such as laser resurfacing, Morpheus8 or skin needling, where some people find redness and swelling settle a little sooner;
  • calming inflammation in sensitised or reactive skin;
  • mild to moderate inflammatory breakouts, using blue light as part of a broader acne plan;
  • general skin quality, as one part of a long-term skin health program.

Its limitations

LED is gentle, and its effects are modest. It won’t noticeably improve skin laxity, deep lines, established scarring or pigmentation on its own. It doesn’t treat the cause of acne, rosacea or other skin conditions, and it isn’t a substitute for medical diagnosis and care. Persistent redness, ongoing acne or a skin condition that isn’t settling may need assessment by a GP or dermatologist.

How does it work?

Photobiomodulation

Photobiomodulation means using low levels of light to influence how cells behave, without heating or damaging them. Red and near-infrared light are absorbed by molecules inside cells, particularly an enzyme in the mitochondria (the parts of a cell that produce energy). This is thought to help cells produce energy more efficiently and to change the chemical signals they send.

In laboratory and clinical studies, those changes have been linked with fibroblast activity (the cells that make collagen), the release of inflammatory messengers, and local blood flow. That is the rationale for using red and near-infrared light to support recovery and calm inflammation.

Blue light

Blue light works differently. Bacteria involved in acne produce natural compounds called porphyrins, which absorb blue light. This sets off a reaction that can reduce the number of bacteria. Blue light only penetrates a short distance, so it affects the surface and the pores rather than the deeper skin.

Dose matters

The effect of light on cells depends on the dose. Too little may do very little, and more isn’t necessarily better: above a certain range, the effect can lessen. Clinic protocols set the wavelength, power and time to deliver a defined dose.

What the evidence shows

The evidence for LED is genuine but limited. Many studies are small, and they use different devices, wavelengths and settings, which makes them hard to compare. Results for recovery after procedures and for mild inflammatory acne are encouraging but mixed. Effects on fine lines and skin quality, where shown, are generally subtle.

Clinic LED and consumer LED

Clinic devices such as Healite II are typically designed to deliver a measured dose of specific wavelengths over a consistent treatment area in a set time. Treatment is given after a skin assessment, with eye protection, and timed around your other procedures.

Home LED masks and wands usually deliver lower power over longer or more frequent sessions. Their quality and specifications vary widely, and some have reasonable supporting data. Few studies directly compare clinic and home devices, so it isn’t possible to say one will work better for you than the other. The main differences are the dose delivered per session, consistency, and the clinical assessment around treatment.

Who may be suitable?

LED may be considered for people who:

  • are having, or have recently had, a procedure such as laser, Morpheus8 or skin needling, where Jodi thinks LED may support recovery;
  • have sensitised or reactive skin, alongside a gentle skincare routine;
  • have mild to moderate inflammatory breakouts and want to add blue light to an acne plan;
  • understand that the effects are gradual and modest, and that LED works alongside other care rather than replacing it.

LED can generally be used across a wide range of skin types, although blue light needs more caution in pigment-prone skin (see below).

Who may not be suitable?

LED is low risk, but it isn’t right for everyone. Treatment may not be appropriate, or may need to be deferred or adjusted, if you:

  • have a condition that makes your skin sensitive to light, such as lupus or porphyria;
  • take medicines or supplements that increase sensitivity to light. Bring a list of everything you take, including herbal products;
  • have recently had a skin treatment designed to make the skin light-sensitive;
  • have epilepsy or migraines triggered by light;
  • have a skin cancer, or a suspicious or changing spot, in the treatment area, which needs medical assessment first;
  • are pregnant, as there is little research on LED in pregnancy, so it is usually deferred;
  • have an eye condition or have had recent eye surgery;
  • have melasma or skin that readily darkens, where blue light may worsen pigmentation and red or near-infrared protocols may be preferred.

Your consultation

Even for a low-risk treatment, Jodi assesses:

  • your medical history, including light-sensitive conditions, seizures or migraines and eye conditions;
  • medications and supplements that may increase light sensitivity;
  • previous procedures, and any treatment LED is being planned around;
  • your skin type and tendency to pigment;
  • your anatomy and the area to be treated;
  • your current skin condition, including breakouts, redness, sensitivity and any spots needing review;
  • your concerns, and whether LED is likely to help with them;
  • your expectations, so you understand what LED can and can’t do;
  • your lifestyle, and whether you can attend a course of sessions;
  • your downtime tolerance, which matters mainly for any procedure LED is paired with.

If LED isn’t likely to add much for you, Jodi will say so.

What happens during treatment?

  1. Jodi confirms your health details and any changes to medicines since your last visit.
  2. Makeup, sunscreen and skincare are removed so the light reaches the skin evenly. After a procedure, your skin is prepared gently, following the instructions for that treatment.
  3. You wear protective eyewear for the whole session.
  4. The LED panel is positioned close to the treatment area, without touching the skin.
  5. The protocol runs for typically 10–20 minutes. Most people feel nothing or a mild warmth, and many find it relaxing.
  6. Afterwards, your usual skincare and sun protection are applied, or the aftercare for your other procedure is continued.

What will I look like afterwards?

After LED on its own, most people look much as they did before. Some notice a slight pinkness or warmth that settles within an hour or so. Swelling, bruising, peeling, crusting, pinpoint marks and tenderness are not expected from LED itself.

Pigment darkening is uncommon, but blue light can trigger it in skin that tans or pigments easily. Tell Jodi if you notice any darkening.

If LED is used after another procedure, how you look and how long you need before social events depend on that procedure, not the LED. LED may help recovery, but it won’t remove the downtime of laser, Morpheus8 or needling.

Recovery timeline

This timeline is for LED on its own. When it is paired with another procedure, follow the recovery timeline for that treatment.

  1. Immediately afterwards

    Skin may feel slightly warm or look a little pink. You can usually return to work and normal activities straight away.

  2. First 24 hours

    Continue your usual skincare and daily SPF 50+. Any pinkness has usually gone.

  3. Days 2–3

    Nothing specific is expected. Occasionally the skin feels a little dry, and a gentle moisturiser helps.

  4. Days 4–7

    If you are on a course, your next session is often within this window.

  5. Weeks 2–4

    For acne or skin-quality courses, any change is usually gradual and becomes easier to judge towards the end of a course.

  6. Following months

    Jodi reviews whether LED is helping and whether to continue, pause or change your plan.

When might I see a result?

This depends on why you are having LED.

  • After a procedure: any effect on redness, swelling or comfort is judged over the days of recovery. Some people notice a difference, others don’t, and the evidence is mixed.
  • Inflammatory breakouts: a course of blue light over around 4–8 weeks may reduce inflamed spots in some people. It has little effect on blackheads, whiteheads or deep cysts.
  • Skin quality: changes, if any, are subtle and build gradually over weeks to months.

Results vary, and LED isn’t a quick fix for any of these concerns.

How many treatments might I need?

Around a procedure, LED is often used for one to a few sessions in the days before or after. For breakouts or skin quality, studies commonly use 1–2 sessions a week for around 4–8 weeks. Your plan will depend on your skin, your goals and how you respond, and Jodi reviews it as you go rather than committing you to a fixed number.

How long do results last?

LED effects are generally temporary. Benefits to recovery relate to the procedure they support. For acne, LED doesn’t change the underlying causes, so breakouts commonly return without ongoing skincare and, where needed, medical treatment. For skin quality, any improvement tends to fade over time without maintenance. Sun protection, a consistent skincare routine and not smoking matter more for long-term skin health than LED alone.

Risks and possible complications

Common, expected effects

  • Mild warmth during treatment
  • Slight pinkness that settles quickly
  • Brightness that some people find tiring on the eyes, even with protection

Less common complications

  • Darkening of pigment or worsening of melasma, mainly with blue light in pigment-prone skin
  • Dryness or mild irritation
  • Headache or eye discomfort
  • Rash or flare in people with light-sensitive conditions or on light-sensitising medicines or supplements
  • Eye injury if protective eyewear isn’t worn
  • No noticeable improvement

Telling Jodi about your health, medicines and supplements before every course helps keep these risks low. Read more about risks and complications.

Aftercare

  • Continue your usual skincare unless Jodi advises otherwise.
  • Use SPF 50+ every day.
  • If LED followed another procedure, that procedure’s aftercare applies.
  • Let Jodi know about any new medicines or supplements before your next session.

Read the full Healite II aftercare guide, including when to contact Jodi.

Pricing

Pricing to come

Fees depend on whether LED is a single session, a course, or part of another treatment, and are confirmed at your consultation.

Frequently asked questions

Does LED hurt or feel hot?

No. Most people feel nothing or a gentle warmth. It doesn’t heat the skin the way laser or IPL does.

Is it UV light? Will it tan or damage my skin?

No. Healite II uses visible and near-infrared light, not UV, so it doesn’t tan the skin. Visible blue light can contribute to pigmentation in some skin types, which is why Jodi checks your skin first.

Is it the same as a home LED mask?

They work on the same principle. Clinic devices typically deliver a measured dose over a consistent area in a shorter session, as part of an assessed plan. Home devices vary widely, and there is little research directly comparing the two, so neither can be promised to work better for you.

Can LED fix my acne?

Blue light may reduce inflamed spots in mild to moderate acne, but it doesn’t treat the causes. Acne that is persistent, scarring or affecting your wellbeing should also be assessed by a GP or dermatologist.

Can it replace laser or needling?

No. LED doesn’t remodel the skin in the way resurfacing or needling does. It is most useful as support for those treatments or as part of a skin health plan.

Why do I need to wear eye protection?

The light is bright, and near-infrared light is invisible, so your eyes can be exposed without you noticing. Eyewear protects your eyes and keeps treatment comfortable.

Can I go back to work or wear makeup afterwards?

After LED on its own, yes, usually straight away. If it was paired with another procedure, follow the instructions for that treatment.

Can I have it while pregnant?

There is little research on LED in pregnancy, so it is usually deferred. Talk to Jodi about what may be suitable during pregnancy and breastfeeding.